Our kit comes in 2 pieces- the bust and the base.
Molded and casted by Gillman Productions, there is only the smallest of evidence of a seamline across the back of Harry's head. There were no obvious bubbles anywhere on the kit. On the bottom of the base, sculptor Mark Van Tine was kind enough to give me an autograph, along with a little illustration. :)
The only negative on the kit was the build in rod to hold the bust to the base somehow got curved backward. So it couldn't just sit without falling over backward. No big deal a brass tube/rod or wooden dowel easily solves the problem.
I primed the bust in the tan Stynylrez primer, and then set out to paint the figure. While Harry shows a lot of gray hair, I started off, as usual, with a dark brown. In the pic you can also see I started the lighter first highlight. The teeth was painted with Army Painters Skeleton Bone. This is close to both V's Dark Sand, and Iraqi Sand - it falls in between actually so if one is too dark and the other too light I have my remedy.
While that was drying I turned my attention to the base. I knew I wanted to paint the name with the multi color look and I found an example where they used just red and yellow. But first I painted the rock V Gray Black. Sculpted in the flat part there are some leaves, a fern and some twigs. Here you see the leaves and the fern painted.
Check back for when Harry goes gray, and we finish this bust up. Thanks for looking.
No comments:
Post a Comment